Finish carpentry · Calgary, AB
Finish carpentry and custom cabinetry in Calgary.
Custom built-ins, wainscoting and trim, made to the millimetre for homes in Calgary, Airdrie, Cochrane and Canmore. Cut on our own CNC, sprayed in our own booth, and installed by the people who drew it.
We reply within 24 hours · Calgary & area
- 20 yrs
- at the bench
- 1
- project at a time
- CNC
- parts cut in-house
- Spray
- finished in our own booth
What we make
Made for your home,
finished with care
We work across the whole interior, but most of what we do comes down to precise woodwork, installed properly.
- 01Built-insCustom cabinetry, shelving and storage built for the room.
- 02Finish CarpentryTrim, casing, wainscoting, stairs and the details that finish a home.
- 03Custom CabinetryKitchen cabinets, islands and vanities made and finished in our Calgary shop.
- 04WainscotingWall panelling, picture-frame moulding and board and batten, laid out for your room.
- 05Window & Door ReplacementReplacement windows and doors, installed and trimmed properly.
- 06Interior RenovationsKitchens, living spaces and whole-floor renovations, start to finish.
The shop
Made under
one roof.
Most renovation companies send cabinetry and finishing to outside shops and then wait for it. We cut parts on our own CNC and spray them in our own booth, so the accuracy, the finish and the schedule stay with us.
One project at a time, from the first measurement to the final adjustment.
Inside the shop- Cutting
- CNC router, parts cut to drawing
- Finishing
- Sprayed, not brushed, in a dedicated booth
- Materials
- Paint-grade MDF, white oak, walnut, maple
- Install
- Scribed and adjusted on site by our own crew
- Workload
- One project at a time, by design
Raw to finished
Built, then
finished in place
The same pieces photographed mid-build
and again once they were done.
How a project runs
From first visit
to final adjustment
The same four steps on every job,
whether it is one built-in or a whole floor.
Step 1 · First visit
Visit and listen
We look at the space and talk through how it needs to work, what matters most and a realistic budget.
Step 2 · Design
Drawings
You see layouts, profiles and finishes on paper and we revise them with you before anything is cut.
Step 3 · Shop time
Made in our shop
Parts are cut on our CNC and sprayed in our booth, so quality and timing stay in our hands.
Step 4 · On site
Installed with care
We install, scribe and adjust, protect your home while we work, and walk through every detail with you.
Tell us about the room.
Send a few photos and a rough idea. We reply within 24 hours.